I rebuild the axles (cv joints, whatever you want to call them) not that long ago. And yet I got a tiny hole in the outer boot for the left axle. This flung grease into the wheel well. While I had the engine it was a good time to fix this issue.

I replaced both the inner and outer boots. The inner boot is not that expensive compared to the laber I was already putting in.

Once annoying thing is the boot clamps. One boot came with the correct sized clamps. The other came with clamps where were way to big. I had to buy an adjustable clamp locally. It is not as nice as a stainless steel crimp clamp, but it works well enough.

Preview Image Size Thumbnail Small Medium Large

Smll Med Lrg the boots still look great	Smll Med Lrg how did this hole develop. Annoying	Smll Med Lrg	Smll Med Lrg grease on the splines during install made separating super easy
Smll Med Lrg	Smll Med Lrg	Smll Med Lrg	Smll Med Lrg
Smll Med Lrg	Smll Med Lrg Clip came in the kit, but I have no idea where it would be used. I pitched it	Smll Med Lrg	Smll Med Lrg
Smll Med Lrg clamp supplied in the kit is way to big. How annoying	Smll Med Lrg	Smll Med Lrg adjust clamp works fine. Cut off the excess	Smll Med Lrg
Smll Med Lrg