I have a running list of things I could design then print with the new 3D printer. Many of them are for the RV. Here is my first batch.

Preview Image Size Thumbnail Small Medium Large

Smll Med Lrg Original plastic cover was shot so I designed a replacement	Smll Med Lrg	Smll Med Lrg	Smll Med Lrg
Smll Med Lrg	Smll Med Lrg 1st attempt is not thick enough and bends, also countersink is not deep enough	Smll Med Lrg	Smll Med Lrg 2nd attempt is much thicker with deeper countersinks
Smll Med Lrg Much better. By the way, printed this in Bambu labs ASA for heat resistence	Smll Med Lrg	Smll Med Lrg Door handle extension printed in PLA	Smll Med Lrg It will have to take lots of torque so I printed it for extreme strength
Smll Med Lrg	Smll Med Lrg	Smll Med Lrg	Smll Med Lrg a little 3M body trim adhesive keeps it from sliding up or down on the door handle
Smll Med Lrg	Smll Med Lrg	Smll Med Lrg	Smll Med Lrg Gives you about 3x the leverage
Smll Med Lrg	Smll Med Lrg	Smll Med Lrg Keeps the blinds from dropping down while driving	Smll Med Lrg
Smll Med Lrg	Smll Med Lrg