P7120823.JPG;Trailer tires were shot|||P7120824.JPG;Not leaking yet which was surprising|||P7120825.JPG;|||P7120826.JPG;|||P7120827.JPG;|||P7120828.JPG;|||P7120829.JPG;|||P7120830.JPG;|||P7120831.JPG;|||P7120832.JPG;|||P7120833.JPG;|||P7120834.JPG;|||P7120835.JPG;Now I have a spare tire|||P7120836.JPG;|||P7120837.JPG;|||P7120838.JPG;|||P7120839.JPG;New strap was cut down to like 10 feet to fit in the winch|||P7120840.JPG;|||P7120841.JPG;|||P7120842.JPG;3d printed box. Not UV safe nor water proof. Probably just my first attempt|||P7120843.JPG;|||P7120844.JPG;|||P7120845.JPG;|||P7120846.JPG;|||P7120847.JPG;This end broke off so I re-rivited it back on|||P7120848.JPG;|||P7120849.JPG;|||P7120850.JPG;|||P7120851.JPG;|||P7120852.JPG;|||P7120853.JPG;|||P7120854.JPG;|||P7120857.JPG;The mast could wear through the bottom of the fiberglass mast hole. Easier to fix before it breaks|||P7120859.JPG;Let's 3D print a plastic disc to fit in the hole|||P7120861.JPG;|||P7120862.JPG;|||P7120863.JPG;A look inside the hull of the boat|||P7120865.JPG;|||P7120866.JPG;|||P7120868.JPG;|||P7120870.JPG;|||P7120873.JPG;|||P7120874.JPG;|||P7120875.JPG;|||P7120876.JPG;|||P7120877.JPG;The 3d printed disc to take the wear from the mast so the hull doesn't have to|||P7120878.JPG;3D file is in the zip attached to this page|||P7120879.JPG;|||P7120884.JPG;The holl is smaller at top then the middle. Confusing|||P7120885.JPG;A little RTV to keep the disc from turning on the hull. That way the mast rotates on the disc|||P7120886.JPG;Installed and ready to get worn down|||