P7300901.JPG;Original plastic cover was shot so I designed a replacement|||P7300902.JPG;|||P7300903.JPG;|||P7300904.JPG;|||P7300905.JPG;|||P7300906.JPG;1st attempt is not thick enough and bends, also countersink is not deep enough|||P7300908.JPG;|||P8010909.JPG;2nd attempt is much thicker with deeper countersinks|||P8010910.JPG;Much better. By the way, printed this in Bambu labs ASA for heat resistence|||P8010911.JPG;|||P8070917.JPG;Door handle extension printed in PLA|||P8070918.JPG;It will have to take lots of torque so I printed it for extreme strength|||P8070920.JPG;|||P8070921.JPG;|||P8070922.JPG;|||P8070924.JPG;a little 3M body trim adhesive keeps it from sliding up or down on the door handle|||P8070925.JPG;|||P8070926.JPG;|||P8070927.JPG;|||P8070928.JPG;Gives you about 3x the leverage|||P8070929.JPG;|||P8070931.JPG;|||P8070932.JPG;Keeps the blinds from dropping down while driving|||P8070933.JPG;|||P8070934.JPG;|||P8070935.JPG;|||AlbumDescription;<p>I have a running list of things I could design then print with the new 3D printer. Many of them are for the RV. Here is my first batch.</p>|||